Electrical Maintenance
158
Low Pressure Cutout Switch Installation
Install the low pressure cutout switch by performing the following steps:
1. Install low pressure cutout switch in the suction line.
2. Route wires into the control box and connect to proper terminals.
3. Perform a controller pretrip test to verify system operation.
Low Pressure Cutout Switch or Suction Transducer Configuration
These units could have either a Low Pressure Cutout switch (41-4473) or a Suction Transducer (41-6150)
installed.
1.
Suction Pressure Sensor
2.
Discharge Pressure Sensor
3.
Suction Service Valve
4.
Discharge Service Valve
Figure 132: Pressure Sensor Location
Figure 133: Low Pressure Cutout Switch Installed
Figure 134: Suction Transducer Installed
Summary of Contents for 098203
