Teledyne ACCQPrep HP125, Installation And Operation Manual

Page: 26 / 142

ACCQPrep HP125
Section 2 Installation
2-10
Connect the included check valve(209016629) to the inject valve
waste line. Ensure that the arrow on the check valve points
toward the waste container. This check valve ensures sample
doesn’t run from the port when the injection syringe is removed.
If an AutoInjector or AutoSampler is installed and manual
injection is also desired, install the included check valve
(209016629) in the waste line from either the inject valve (if no
AutoInjector or AutoSampler is installed) or the waste line from
the sample load pump. Ensure that the arrow on the check valve
points toward the waste container. This check valve ensures
sample doesn’t run from the port when the injection syringe is
removed.
2.4 Installing the
AutoSampler
These instructions assume that the AutoSampler was purchased
with a new ACCQ
Prep . In that case, the AutoInjector portion of
the AutoSampler is already installed in the ACCQ Prep . If not,
please refer to installation instructions included with the AutoIn-
jector.
To install the AutoSampler:
1. Carefully unpack the Z-Drive and remove the packing
materials from the Y-axis arm (Figure 2-15).
Figure 2-15 AutoSampler Module and Z-Drive
2. Find the Y-axis carriage on the arm of the AutoSampler
Module. The Z-Drive will be attached to this carriage (Fig-
ure 2-16).