Teledyne ACCQPrep HP125, Installation And Operation Manual

Page: 17 / 142

2-1
ACCQ Prep HP125
Section 2 Installation
2.1 ACCQ Prep Installation
The following section will cover the installation, connection of the
pump, and a review of the priming steps.
Note
When the system ships, it will ship in two boxes to mini-
mize the weight. One box will contain the unit and the
other box will have the pump and assorted accessories.
Tools Required • Hex wrench (included with the pump module)
•
1
/
4
” open end wrench
• Fitting wrench (allows more secure connection of ‘finger
tighten’ fittings) (Wrench is included in the ACCQPrep
accessory kit)
2.2 Setting Up the System
The ACCQ Prep chassis including AutoInjector, Solvent Selector
Valve Module, and Column Selector Valve Module, but without
the pump assembly, weighs up to approximately 64 pounds (29
kg). Handles are provided on each side of the instrument to facil-
itate lifting.
CAUTION
A two person lift is recommended to prevent injury.
The pump assembly weighs 25 pounds (11.5 kg) resulting in a
final weight of 93 pounds (42.3 kg) with the column cover
installed, but not including an optional AutoSampler.
The fraction collector arm is secured to prevent damage during
shipping. The arm securing bracket should be removed at this
time.
1. Loosen the bracket’s two thumbscrews along the sides of
the arm (Figure 2-1).
Figure 2-1 Remove arm stowing bracket and spacer
Spacer
Thumbscrew
Thumbscrew