Teledyne ACCQPrep HP125, Installation And Operation Manual

Page: 24 / 142

ACCQPrep HP125
Section 2 Installation
2-8
Note
If accessible, the outlet end of the P-trap drain tube may be
used to refill the P-trap.
5. Route the attached tubing from the ELSD exhaust port
away from the system. This will prevent unnecessary sol-
vent vapor alarms.
Note
The ELSD exhaust will contain fine particles of compound. If
using outside of the hood, ensure that the exhaust port tubing
is routed to an exhaust handling system that meets your safety
and environmental requirements. Do not use tubing smaller
than the exhaust tube. If the exhaust is restricted, some of the
gas flow could be diverted out the P trap drain resulting in
reduced sensitivity and the need to route the P trap drain to an
exhaust. In normal operation, the exhaust gas is dry and does
not require a waste collection container.
CAUTION
Discontinue use of the ACCQPrep if liquid is present at the
Pump Drain. Contact Teledyne ISCO technical service for
assistance with correcting the leak.
2.2.5 Priming Steps The system will require priming with the desired solvents. To
prime the system:
1. Press the red switch, next to the front USB port, to the O
N
position to boot up the system (Figure 2-12).
Figure 2-12 Front USB and On switch
2. Turn the prime valve to the P
RIME
position (Figure 2-13).