Teac LX Series, Instruction Manual

Page: 47 / 148

Starting Program
2-21
When multiple LX-10L/20Ls are found in the same segment, the dialog box appears as shown below. In such
a case, select the check box of the LX-10L/20L to be connected, and click the OK button.
On the real time PC recording of the LX-10L/20L, the speed of the data transfer cannot catch up to the
recording throughput per a time unit. In this scenario, the recording will stop automatically when the memory
buffer of the LX is getting full with the un-transferred data. It is caused by depending on the PC specifications
and the networktraffic; however, the following sampling setting is not applicable for the real time PC
recording.
Sampling Frequency 96 kHz x 8 ch
（
Memo voice ON/OFF
）
If multiple LX units by using LX Navi are connected to a single PC (regardless with IEEE 1394 or LAN), the wave
form settings and the data folder settings of each LX may cause conflict to others because the LX Navi shares
the common save area. Use each LX for each PC.
The Main Window will be displayed by starting LX Navi when the connection completes.
See Section 3 Introduction to LX Navi.