Teac LX Series, Instruction Manual, Page: 60 / 148

System Settings
4-4
Monitor/Generator
In
Signal
, select the monitor channel or the type of the generator output signals (only for the LX-20/20L) to
be output from the MON OUT connector on the rear panel. If you don't want to monitor any channel, set
NONE.
In Range set the output range. You can set the output range in 0.1 V steps, from 1 V to 5 V.
Click
Property
to set the output range of the monitor channel or the details of the generator output signal.
In
Signal
, select the monitor channel or the type of the generator output signals (sine, sweep sine, pulse,
pink noise, or white noise from the MON OUT connector of the LX-20/20Ls).
When you select the generator output signal, you can select the following parameters show at the dialog.
(The parameters can be set are automatically appeared depending on the selection of the output signal.)
Sin/Sweep
Start Freq
: Set the start frequency (Hz) when <sine> or <sweep sine> is selected at
Signal
.
Stop Freq
: Set the stop sweep frequency (Hz) when <sweep sine> is selected at
Signal
.
Rate
: Set the sweep rate when <sweep sine> is selected at
Signal
.
Pulse
Pulse Width
: Set the pulse width when <pulse> is selected at
Signal
.
Pulse Interval
: Set the pulse interval when <pulse> is selected at
Signal
.
Select the output range at
Range
from 1 V to 5 V at 0.1 V steps.
See Section 6 for the specifications of the generator output.
z
You cannot use the tachometer pulse input channels and the generator output function at the time.
z
You cannot use the monitor output of the analog signal when recording at the low-speed sampling (1
kHz to 1/60 Hz).