Teac LX Series, Instruction Manual

Page: 138 / 148

File Format
6-24
z
Explanations of Header File
DATASET File name
VERSION 1 (This is a fixed value.)
SERIES Number of the channel used for recording. The channel name is after the underscore.
DATE Date when recording started (month-day-year)
TIME Time when recording started (hour: minute: second)
RATE Sampling frequency (Unit: Hz)
VERT_UNITS Physical/engineering units of each channel
HORZ_UNITS Time axis units (Sec: This is a fixed value)
COMMENT Comment entered using
File
and
New
.
NUM_SERIES Number of recording channels
STORAGE_MODE Data order. Fixed as INTERLACED because this is the scan order.
FILE_TYPE
Fixed as INTEGER because this is a 2-byte integer for 1 data item.
SLOPE Coefficient used when converting data to physical/engineering units
X_OFFSET Location of the beginning data on the time axis. Usually is 0.
The set value (in seconds) is written using
minus for the pre-trigger time. Even if you set the number of scans for Pre-trigger, this will be in
seconds. (Values below the decimal point are discarded.)
Y_OFFSET Offset used for converting data to physical/engineering units.
NUM_SAMPS Number of data items recorded per channel
DATA The information written after this entry is proprietary to this device, and indicates information different
from the DADiSP format. The information below is not recorded when recording to a PC. Also, it is not
recorded in the header file on the PC when recording to a PC while recording to memory or the media.
DEVICE LX-10/LX-20 (This is a fixed value.)
(The information below is not recorded when recording to a PC.)
SLOT1_AMP
The ID-name, number of channels, and versions of the amp in slot 1, next to SLOT2_AMP.Depending
on the system conguration.
CH1_ The following information is written after the underscore: channel number, amp type, range setting,
filter setting. (This is always ON for a DC amp.)
ID_NO ID number
TIME Recording start date and time, recording stop date and time (YYYYMMDDhhmmss)
REC_MODE Recording destination device (MEMORY, MO, PC CARD, PC)
START_TRIGGER Recording start conditions: COMMAND: Interface command
PANEL: FWD button of the front panel
LEVEL: Level trigger
DATE: When
Repeat Count
is 1 in the interval action
TIMER: When
Repeat Count
is 2 or more in the interval action
EXT: External trigger
TIME_OUT: Timeout
,PRE: Added for a pre-trigger
STOP_CONDITION Recording stop conditions: COMMAND: Interface command
PANEL: STOP button of the front panel
LEVEL: Level trigger
TIMER: Specified recording time
EXT: External trigger
MEMORY_FULL: Memory is full
MEDIA_FULL: Media is full
POST: Added for a post-trigger
START_PRE_COUNT Number of scans recorded by a pre-trigger
STOP_POST_COUNT Number of scans recorded by a post-trigger
MARK Number of scans at the instant an event mark was attached.
ID_END The following information applies to the LX hardware, etc.
VOICE_MEMO The number of bits per sample for voice-memo data. Data size (bytes)
LX10_VERSION Firmware and PAL version of the LX-10
(LX20_VERSION) for LX-20