Teac LX Series, Instruction Manual, Page: 144 / 148

Troubleshooting
7-2
Troubleshooting
If you encounter one of the following problems, check whether the recommended actions solve the problem
before you request a repair.
Problem Possible cause and recommended action
No power. Check whether the DC voltage is low.
The LX Navi software does not
recognize the LX. Make sure that the IEEE 1394 interface card is one of the
recommended cards.
Make sure that both the LX and the PC have matched IP
addresses.
Power on the LX again, and then restart LX Navi.
The MO disk is not recognized in the
New
dialog box.
Make sure the media is formatted.
Make sure you are using the specified media.
You cannot record to the media. Make sure that the media is inserted.
Make sure that the media is formatted.
Make sure that the MO disk is not write-protected.
The
Auto Saving
function for
automatically saving to the media is not
working.
Make sure that the media is formatted.
Make sure that the media is not full.
Make sure that the
Auto Saving
option is selected. Note
that turning off the power will disable the
Auto Saving
option. You must enable it each time you turn the power
on.
The buttons on the main unit are
disabled. Make sure that panel is not locked (P LOCK button). If the
panel is locked, release the lock.
The eject button on the main unit is
disabled at the MO model. Note that while LX Navi is running, the eject button on the
LX MO drive is disabled.
You cannot set the sampling frequency. Make sure that number of the channels you activate is
larger than available number of the channels at the
sampling frequency in case turning on the tachometer input
channels.
A write or read error occurred on the MO
disk. Clean the MO disk and the lens. To clean the MO disk, use
the cleaning kit TZ-381.
To clean the lens, use the cleaner 0240470.
If you perform the recommended action but the problem remains, contact TEAC's service department.