Teac LX Series, Instruction Manual

Page: 105 / 148

LX Stand-alone Operations
5-23
Recording to Memory
When recording to memory while using LX as a stand-alone device, after recording stops keep the LX powered
on, connect to a PC, and transfer the data in memory to an MO disk or the PC.
1.
In the LX Navi, from the
File
menu select
New
.
2.
Specify memory as the recording device, specify the file name, and then click
OK
.
3.
Terminate the LX Navi.
4.
Power off the LX, remove the IEEE 1394/LAN cable from the rear, and move the LX to the place where you
want to take measurements.
5.
Power on the LX.
6.
Press the REC button, and then press the FWD button. Recording starts.
7.
Press the PAUSE button.
Recording will pause. Recorded data will be grouped into one ID.
After this, each time the FWD and PAUSE buttons are pressed, an ID will be recorded, and the ID numbers will
be incremented automatically.
8.
To stop recording, press the STOP button.
z
Take care in this situation because the data in memory will be lost if you again press the REC button, start
reproducing, or power off the LX.
9.
Use an IEEE 1394/LAN cable to connect to the PC.
10.
Start the LX Navi.
11.
From the
File
menu choose
Copy
, and copy the data recorded to memory to the PC.
z
When recording to memory using LX as a stand-alone device, do not select the Auto Saving option (
File
,
New
, and then
Auto Saving
). When recording to memory, the system does not know how much free
space is left on the media, so there is a danger that some data might be lost when saving. Also note that,
even if the
Auto Saving
option is selected, powering off the LX resets this option to the disabled status.