Teac LX Series, Instruction Manual

Page: 19 / 148

Names and Parts
1-9
9 Output connector (When the analog playback amp card is installed into the slot.)
Outputs the reproduced signal. Outputs the input signal during recording-standby status or during
recording. You can set the output range in 0.1 V steps, from 1 V to 5 V.
10 Output level LED (When the analog playback amp card is installed into the slot.)
When the output signal for some channel is larger than +/-10% of a set output range, the LED glows green.
When the signal e/-115% of the range, the LED glows red.
11 P LOCK button
Pressing this button for 3 seconds causes the lamp to glow and disables the five buttons on the left: STOP,
REC, FWD, PAUSE, and EVENT. To release the lock, again press the button for 3 seconds.
12 Recording/reproduction control buttons
Buttons used for recording or reproduction. Details are given later.