COLLARING MACHINE
29
S-80
6.2.2.2.3. AUTOMATIC SCREEN
1
2
3
4
5
1
Do homing by tapping the button: Homing resets all machine axis positions to
home position.
The homing position is the starting point of the work cycle.
2
Center position: Run the machine to the preset position of the laser beam cross
(The collar center point). The position is set on “Positions” screen.
3
Tool unit:
Tool number (This has to be set to the tool magazine, tool information can be
found on Tool settings screen).
Tool fasten, for fastening the tool . Automatic function.
Tool release, for returning the tool . Automatic function.
See 7.1.1. Collaring tool setup
4
Tube handling: Clamp Fasten / Clamp release:
Tap button “Clamp Fasten” to run the sequence: the clamp close-sequence is
done, clamp is fully fastened and the air pressure is left on.
Tap button “Clamp release”: the clamp release-sequence is done, clamp is
released (air pressure off).
5
Gear handling: Tap either “Start” button to switch gear ratio (Mainly for testing).
Tool changing is done on 1:1 ratio, collaring on 1:4 ratio. Homing run switches
the gear ratio to 1:1 to enable tool change.
