INSTRUCTION MANUAL
68
8.2. COLLARING TOOL MAINTENANCE
¨NOTE!
¨
Keep the collaring tool clean.
The collaring tool does not need any regular maintenance. If the collar quality starts to
decrease, the collaring pins are worn and have to be renewed.
8.2.1. DISMANTLING AND REASSEMBLING OF THE COLLARING TOOL
Place the tool to a vice bench or similar to keep
steady, the tool is placed to the jaws as shown
in the picture.
Place the tool to a vice bench with the cone
facing downwards.
Tighten the tool to the vice by the cone
bottom.
Open the tool by the hex head (RH thread,
spanner size 46).
Turn the head to cone upwards position and
screw the cone open.
Beware, the pins may fall out when the drive
gear is lifted.
The tool must be tightened very well after
assembly.
Tighten to 200Nm
.
After tightening check the operation of the tool
(by rotating it by hand)!
