COLLARING MACHINE
69
S-80
8.2.2. REPLACING THE COLLARING PINS
See 6.5.2.2. Removal of the collaring tool: Remove worn tool from the machine.
The collaring tool does not require dismantling when the pins are changed:
3
2
1
Loosen the four (M6) retainer screws (1).
Hold the tool by the cone (2).
Rotate the tool cover (3) clockwise (as
seen from the cone side) until the pins
are fully out.
(The tool body may rotate along)
Remove the pins.
Place the tool on the table, cone pointing
downwards.
Put the new forming pins into the holes
of the collaring head.
Push the pins inward and simultaneously
rotate the tool cover counterclockwise
until the pins are fully in, and the cover
does not turn anymore.
Flat surfaces of the forming pins are
against each other and the pin lugs (4)
are pointing inwards when the pins are
in.
