COLLARING MACHINE
7
S-80
1.4. PERSONAL PROTECTIVE EQUIPMENT FOR THE OPERATOR
Always wear the appropriate personal protective equipment, and use extreme caution
when operating the machine.
The local safety guidelines and regulations are to be followed for safe operation. The
T-Drill instruction manual will not repeal the federal, state and local regulations.
Use overalls when operating the machine.
2. GENERAL SAFETY INSTRUCTIONS
Read the instruction manual attentively before installation, operation or maintenance of
the machine.
The T-DRILL S-80 is to be used only for collaring in the specific way as described in this
manual.
When operating the T-DRILL S-80 it must be fastened on the floor.
Do not exceed the capacity of the machine.
Before removing or mounting a collaring head or a clamp, the electric current supply
must be disconnected by pushing the power OFF (O) button in the front panel.
Disconnect power before carrying out any maintenance or repair inside the machine.
Do not keep any loose objects or tools on the machine.
Make sure the ventilation is sufficient.
Always use protective glasses when using the S-80 unit.
Always wear protective gloves when handling the collaring tool.
Study also the safety data sheet concerning the lubricant which is supplied with the
machine.
When pressing the Emergency switch (STOP-button) all functions of the S-80 collaring
machine are immediately interrupted.
After installation of the machine and before using the functions of the S-80 collaring unit,
carry out the measures described in chapter “start-up checking”.
¨NOTE!
¨
Always keep this instruction book at hand for any future use.
