ENGINE 3-85
• Install dowel pins
1
and new gasket
2
.
• Install the clutch cover
3
and tighten its bolts to the specified
torque.
f
Clutch cover bolt: 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
STARTER MOTOR
• Apply grease to the new O-ring.
99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
PISTON RING
• Install the piston rings in the order of oil ring, 2nd ring and 1st
ring.
• The first member to go into the oil ring groove is a spacer
1
.
After placing the spacer, fit the two side rails
2
.
NOTE:
* Side designations, top and bottom, are not applied to the
spacer and side rails: you can position each either way.
* When installing the piston ring, be careful not to damage the
piston.
* Do not expand the piston ring excessively since it is apt to be
broken down.
* When installing the spacer, be careful not to allow its two ends
to overlap in the groove.
A
INCORRECT
B
CORRECT
