CHASSIS 8-79
• Apply grease on the recessed portion of the joint plate holder
3
. Then install the joint plate
0
on the tool, its stamp mark
must face the joint plate holder
3
side.
• Set the drive chain on the tool as illustrated and turn in the
adjuster bolt
5
to secure the wedge holder & wedge pin
4
.
• Turn in the pressure bolt “A”
6
and align two joint pins
8
properly with the respective holes of the joint plate
0
• Turn in the pressure bolt “A”
6
further using the bar
7
to
press the joint plate over the joint pins.
• Continue pressing the joint plate until the distance between
the two joint plates come to the specification.
Joint plate distance specification
B
JOINT PIN STAKING
• Set up the special tool as shown in the illustration.
1
Tool body
2
Grip handle
3
Pressure bolt “A”
4
Adjuster bolt (without hole)
5
Staking pin (stowed inside grip handle behind rubber cap)
6
Bar
• Apply a small quantity of grease to the staking pin
5
.
DID
19.55 – 19.75 mm (0.770 – 0.778 in)
If pressing of the joint plate makes the dimension out
of specification excessively, the work must be carried
out again by using new joint parts.