8-78 CHASSIS
• Place the drive chain link being disjointed on the chain holder
8
of the tool.
• Turn in both the adjuster bolt
6
and pressure bolt “A”
3
so
that each of their end hole fits over the chain joint pin properly.
• Tighten the pressure bolt “A”
3
with the bar.
• Turn in the pressure bolt “B”
4
with the bar
5
and force out
the drive chain joint pin
9
.
NOTE:
•
Continue turning in the pressure bolt “B”
4
until the joint pin
has been completely pushed out of the chain.
•
After the joint pin
9
is removed, loosen the pressure bolt “B”
4
and then pressure bolt “A”
3
.
• Remove the joint pin
9
of the other side of joint plate.
DRIVE CHAIN CONNECTING
JOINT PLATE INSTALLATION
• Set up the special tool as shown in the illustration.
1
Tool body
5
Adjuster bolt
2
Grip handle
(without hole)
3
Joint plate holder
6
Pressure bolt “A”
(engraved mark “F520”)
7
Bar
4
Wedge holder & wedge pin
• Apply grease to the new joint pins
8
, new O-rings
9
and
new plates
0
.
• Connect both ends of the drive chain with the joint pins
8
inserted from the wheel side
A
as installed on the motorcycle.
Joint set part number
DID: 27620-48H10
(F520)