Strautmann Super-Vitesse CFS 3101, Operating Instructions Manual, Page: 56 / 225

Design and function
56 Super-Vitesse CFS 3101, 3501 / Super-Vitesse CFS 3101 DO, 3501 DO 10.13
5.5.2 ISOBUS control of automatic charging system
The automatic charging system (1):
 can be switched on and off via the ISOBUS
control set,
 mainly consists of the sensing band (2), the
actuating plug (3) and the control dial (4),
 switches the transport floor automatically on
and off for uniform and complete filling of
the cargo space,
 permits to adapt the filling degree of the
loaded material in the cargo space in 5%
steps.
Fig. 24
The higher the set filling degree, the higher the transport floor feed
rate and the smaller the filling capacity.
When using the machine as a forage wagon, the loaded material piles up at the front grating of the
cargo space during charging. The loaded material piling up deflects the sensing band upwards and
actuates the control dial via the actuating plug.
As soon as the deflected sensing band reaches the lowest set position, the transport floor
automatically starts running at low feed rate and conveys the loaded material to the back. Increasing
filling of the front section of the cargo space initiates a further deflection of the sensing band. The feed
rate of the transport floor increases in proportion to the deflection of the sensing band.
As soon as the deflected sensing band reaches the highest set position, the loaded material is
conveyed to the back at maximum feed rate. The transport floor stops as soon as the front section in
the cargo space has been cleared and the loaded material does not deflect the sensing band upwards
any more.
A calibration of the automatic charging system helps to separately set the lowest position of the
sensing band for switching the transport floor on and off and the highest position of the sensing band
to switch over to maximum feed rate. Observe the information in the chapter "Calibrate automatic
charging system", page 136.
5.5.3 Deactivate automatic charging system and stop transport floor
Machine without dosing drums
An electrical pressure switch as signal generator for the automatic charging system is mounted on the
inside of the tailgate. If the machine is fully charged:
 the ISOBUS control set will generate an acoustic signal (horn sound) and a visual signal "Forage
wagon full".
 the automatic charging system will be deactivated and the automatic feed function for the
transport floor will be switched off.
Machine with dosing drums
The bottom dosing drum will evade to the rear if the loaded material applies a particular pressure to
this dosing drum. The switching plate releases an electrical pressure switch and disconnects the
automatic charging system and the hydraulic drive of the transport floor. The control set
simultaneously displays the message "Forage wagon full".