Service and maintenance of machine
Super-Vitesse CFS 3101, 3501 / Super-Vitesse CFS 3101 DO, 3501 DO 10.13
169
Cleaning by means of pressure washer / steam blaster
It is absolutely imperative to observe the following when using a
pressure washer/steam blaster for cleaning:
Admissible injection pressure: max. 80 bar.
Water temperature: max. 60°C.
Distance between cleaning nozzle and machine: min. 300 mm.
Nozzle spraying angle: min. 25°.
Never aim the cleaning nozzle jet at machine parts at right
angles.
Never aim the cleaning nozzle jet of the pressure washer/steam
blaster
directly at lubrication points and bearings,
directly at hydraulic components,
directly at rubber seals (e.g. at the door of the driver's
cabin).
Do not clean electrical components such as control set,
weighing rods, distributor boxes, weighing computer.
Do not clean chromium-plated components.
Do not use any chemical additives.
12.4
Lubrication of machine
Lubricate all bearings and lubrication points according to the
lubrication plan.
Remove dirt from the lubricating nipples.
Use environmentally friendly, biodegradable oils and greases
where lubricants may penetrate the fodder or the ground. For
further information, contact your specialist for agricultural
machinery.
Beware not to exceed a lubricating pressure of 250 bar, when
using high-pressure grease guns for lubricating. Damage to
bearings, seals etc. may occur if the grease gun used is not
equipped with a protective device.
Observe the included sub-supplier documentation for lubrication of
the propeller shaft(s)!