Settings
Super-Vitesse CFS 3101, 3501 / Super-Vitesse CFS 3101 DO, 3501 DO 10.13
147
1. Set the operating height of the pick-up via
the left-hand and right-hand pick-up spindle
(1).
2. Lower the roller feelers (2) of the pick-up
onto a solid, even surface.
3. Secure tractor and machine against
accidental starting and rolling.
4. Set the height of the additional roller feelers
(3) via the left-hand and right-hand spindle
(4) such that the roller feelers bear the
largest load.
For this purpose, the frame (5) of the
additional roller feelers must be aligned via
the two spindles such that the additional
roller feelers are set at the same height or
slightly higher than the roller feelers.
4.1 Remove the bottom linch pin (6).
4.2 Use one hand to hold up the frame,
while using your other hand to turn the
spindle.
4.3 Secure the spindle by means of the
linch pin.
Fig. 90
5. Completely lift the pick-up.
The frame must be beneath the check
screws (7). The minimum distance between
the additional roller feelers and the CFS
drum (8) must be 10 mm. Adjust the
distance if necessary.
Fig. 91
9.1.3
Set holding-down device with pulley
The swathe size determines the distance between pick-up and holding-down device/pulley.
WARNING
Risk of becoming entangled and being drawn in by the powered
pick-up!
It is not allowed to operate the machine without holding-down device
and pulley. Holding-down device and pulley also serve as a protective
device.
CAUTION
Risk of crushing and shearing within the area between the pick-
up and the carriers for the holding-down device with pulley!
Make sure that people leave the swivelling range of the carriers for
the holding-down device with pulley before setting the distance
between pick-up and holding-down device.