Chapter 2. Unpacking and Installation
EK–SMCPP–UG. A01
2–15
12. Still facing the side with the panel removed, install a latch on the left front
top vertical cabinet rail through the kep nuts with the 10/32” screws
provided. Install a receiver on the right front top of the vertical cabinet rail
through the kep nuts with the 10/32” screws provided.. As you are standing
facing the side of the cabinet with the side panel removed, latches and
receivers should be oriented with the black colored part of the assemblies
facing outwards. Repeat this step at the bottom of the cabinet, again with the
latch to the left and the receiver to the right as you are facing the cabinet
side with the side panel removed. Note that the latch has the movable part
while the receiver does not.
13. Turn and face the side of the other cabinet with the sidepanel removed.
Repeat the procedure in Step 7 for the second cabinet.
14. Roll the two cabinets close together, aligning the joiner latches to the joiner
receivers.
15. Insert the large Allen wrench (provided) into one of the tool receptacle
holes on a bottom latch and turn clockwise to latch. Turn until the receiver
and latch “clicks” into place. Continue turning the Allen wrench until it can
not be turned further. Repeat for the other bottom joiner latch. Repeat for the
top joiner latches.
16. Slide the notch at the bottom of the front trim bracket over the large head
bolt that you attached to the lower front side of the left cabinet. Rotate the
upper part of the front trim bracket so that it slides in beneath the top trim
piece, which was installed in Step 5, and lock into place with a screw
through the top trim piece.
17. Slide the notch at the bottom of the rear trim bracket over the large head bolt
that you attached to the lower rear side of the left cabinet. Rotate the upper
part of the rear trim bracket so that it slides in beneath the top trim piece,
installed in Step 5, and lock into place with a screw through the top trim
piece.
