RA7000 and ESA10000 Storage Subsystems
5–14
EK–SMCPP–UG. A01
5.10 Replacing a PVA
Perform the following procedure to remove or install a PVA module without
turning off the subsystem (see Figure 5-7).
1. Rotate the left-hand and right-hand levers outward from the unit.
2. Pull the PVA straight out to disconnect it from the backplane and clear of the
subsystem.
Figure 5–10 PVA Module Replacement
Perform the following procedure to install an PVA (see Figure 5-7).
1. Insert the replacement PVA into the guide slots and push it in against the
backplane connector. Be sure the two levers are straight out from the unit to
allow engagement with the brackets.
2. Rotate the levers in toward the unit to fully seat the PVA.
