Chapter 5. Replacing Components
EK–SMCPP–UG. A01
5–5
5.4
Cache Module Removal
Figure 5–3 Cache Module Replacement
CXO5822A
1 2 3 4 5 6
Card cage
Cache
module
Lever
Card guide
1. Pull the lever on each side of the module to release it from the card cage.
2. Slide the module out of the shelf (noting which rails the module was seated
in) and place on an approved ESD work surface or mat.
WARNING
Do not allow the write-back cache to contact any
conductive surface, or injury and/or equipment
damage may result.
Use the following procedure to install the write-back cache module:
1. Slide the write-back cache module into the appropriate slot in the shelf
and be sure the levers are pulled straight out.
2. Use a gentle up-and-down rocking motion to help seat the module into the
backplane. Press firmly on the module until it is seated. Finally, press the
levers firmly once more to make sure the module is seated.
