Chapter 2. Unpacking and Installation
EK–SMCPP–UG. A01
2–35
2.6.3 Installing the AC Input Power Controller
There are no external indications of a power controller failure on the ac power
controller itself. Both status LEDs on the power supply being off indicate a
possible power controller failure. Use the following procedure to install a new
AC power controller. Refer to Figure 2-23.
1. Press 0 on the AC input power controller ON/OFF switch.
2. Insert the AC input power controller into the ESA10000 enclosure .
3. Tighten the two retaining screws at the top and bottom of the power
controller.
4. Connect the AC power cord to the power controller.
5. Press
I on the AC power controller ON/OFF switch.
6. Observe the power supply status LEDs for proper operation.
