Siemens 6GA7202-2AA10-1BF1, Operating Instructions Manual, Page: 97 / 168

Connection
In this group, you set the parameters for the connection interfaces.
Table 8-24 Connection
Parameter Possible values Default Description
Source Deactivated DI/DO Not relevant for CenSOR
Debouncing Deactivated 8
Text • None
• UDP
• PROFINET IO None Specify the interface over which the result text is output.
• None: The result string is not output.
• UDP: The result string is output via a UDP connection.
• PROFINET IO: via PROFINET IO;
depending on the "IP mode" input box in the "Commu‐
nication" → "Interfaces" menu
Note
The result string can only be output via PROFINET IO if
you have selected the value "PROFINET IO" in the "Con‐
trol" drop-down list (see below).
Result • None
• DI/DO
• PROFINET IO DI/DO Not relevant for CenSOR MV540 H
Control • DI/DO
• PROFINET IO DI/DO Specify the interface over which the signals (DISA, SEL0,
SEL1, SEL2, SEL3, TRN, RES, IN_OP, TRD, RDY) are transfer‐
red.
• DI/DO: DI/DO interface (possible only when "Text" =
"PROFINET IO")
• PROFINET IO; depending on the "IP mode" input box in
the "Communication" → "Interfaces" menu
Source program for
saving
• New
• 1
• 2
• ...
• 15
New Select the source program that the controller accesses as a
template. The controller creates new programs based on
the selected source program.
Diagnostics transfer
In this group, you specify the parameters for the transfer of diagnostic data.
Note
Transfer of images or data records
If you have set "Stack" as the buffer type under "Settings > Options > Diagnostics & monitoring
> Report", images and data records are only transferred until the stack is full.
Parameterization
8.4 Settings
SIMOCRANE CenSOR
Operating Instructions, 07/2021
95