Siemens 6GA7202-2AA10-1BF1, Operating Instructions Manual, Page: 79 / 168

Auto-trigger
Parameter Possible values Default Description
Acquisition interval 50 … 100000 ms 50 ms Enter the interval at which image acquisition is to be
repeated automatically. This is also the time you al‐
low the camera for processing.
Note
The acquisition interval corresponds to the interval
at which measured values are updated. Values be‐
tween 50 and 100 ms are recommended for crane
applications.
8.2.3.3 Lighting
Table 8-14 Lighting
Parameter Possible values Default Description
Lamp
• Internal
• External
External
Select the lamp you are working with.
If you subsequently change the parameters of a se‐
lected lamp or connect a different lamp, programs
that use these lamps (internal or external) are
marked as non-executable. You must save the rele‐
vant program again.
Note
You define which internal and/or external lamp is
connected in the "Lighting" group of the "Options"
menu.
Product name Depends on the option se‐
lected under "Lamp" Depends on the op‐
tion selected under
"Lamp" The product name of the selected lamp is displayed.
Operation • Flash
• Off Depends on the op‐
tion selected under
"Lamp" Depending on the lamp used, you can select the
operating mode in which to operate the lamp.
For lamps that support only one of the two modes,
the setting is fixed.
Polarized On / Off Off (deactivated) Not relevant for SIMOCRANE CenSOR MV540 H
Main beam
Unpolarized
Parameterization
8.2 Application
SIMOCRANE CenSOR
Operating Instructions, 07/2021
77