Siemens 6GA7202-2AA10-1BF1, Operating Instructions Manual, Page: 87 / 168

Parameter Possible values Default Description
Skew
Smoothing time 0 ... 10 s 0.00 Smoothing time for smoothing of the skew
measured value
Skew2
Offset -180° ... +180° 0.00 Calibration value for the Skew2 measured
value
Skew2
Smoothing time 0 ... 10 s 0.00 Smoothing time for smoothing of the Skew2
measured value
Distance
Smoothing time 0 ... 10 s 0.00 Smoothing time for the distance measured
value
Limit
Parameter Possible values Default Description
Reflector distance
Min. 10 ... 100 000 mm 100 mm The reflector distance must be at least as high
as the set value. Otherwise the reflector dis‐
tance will be set to this value.
Reflector distance
Max. 10 ... 100 000 mm 64 000 mm The reflector distance must not be higher
than the set value. Otherwise it will be set to
this value.
Note
Limit
These two parameters are used as an additional plausibility check. They can prevent a pattern
which is similar to a reflector but which is situated outside the possible distance range from
being incorrectly detected as a reflector.
If the set maximum or minimum limit is violated, a corresponding status bit is set (see tables in
the chapter Principle of data exchange for PROFINET IO (Page 121)).
Parameterization
8.2 Application
SIMOCRANE CenSOR
Operating Instructions, 07/2021
85