Siemens 6GA7202-2AA10-1BF1, Operating Instructions Manual, Page: 93 / 168

Ethernet
In this group, you set the parameters for the Ethernet interface.
Table 8-18 Ethernet
Parameter Possible values Default Description
IP mode • DHCP
• Manual
• PROFINET (FB79)
• PROFINET (Ident
profile)
DHCP Assignment of the IP address to the camera in the network:
• DHCP Automatic (DHCP = Dynamic Host Configuration
Protocol)
• Manual: Manual assignment
• PROFINET (FB79) / PROFINET (Ident profile):
Automatically by the I/O controller
IP address
(only if IP mode =
manual or DHCP
server) xxx.xxx.xxx.xxx 0.0.0.0 IP address of the Ethernet interface of the camera.
(An IP address consists of four numbers separated by peri‐
ods; each of these numbers is in the range 0 to 255.)
Subnet mask 255.xxx.yyy.zzz 255.255.255.0 The subnet mask indicates which part of the IP address
specifies the network and which part specifies the camera:
If a bit is set in the binary representation of the subnet
mask, the corresponding bit of the IP address belongs to the
network address. If no bit is set, the bit belongs to the ad‐
dress of the camera.
In binary terms, xxx.yyy.zzz requires that the left part be
made up of ones without a gap and the right part be made
up of zeros without a gap. Example: 11111111.10100000
is not permitted.
Note also: zzz ≤ 254
Gateway xxx.xxx.xxx.xxx 0.0.0.0 Gateway IP address
IP address of the network node that can establish connec‐
tions from within the current subnet.
This is always required when there are devices in more than
one subnet. In this case, you can only establish connections
from the camera to other devices (e.g. to the (S)NTP server)
via the gateway.
Your network administrator must usually let you know if all
the devices are in the same subnet.
Notes
• If the (S)NTP server is not addressed by the camera, the
gateway IP address is not required.
• If a broadcast address is configured as the gateway IP
address, the camera cannot be configured using the Pri‐
mary Setup Tool (PST) or with the "Edit Ethernet node..."
functionality of the SIMATIC Manager. In this case, it is
also not possible to read out the configuration of the
camera using these programs.
Parameterization
8.4 Settings
SIMOCRANE CenSOR
Operating Instructions, 07/2021
91