Shihlin electric SL3 Series, User Manual

Page: 164 / 211

Appendix 1 Parameter table
Appendix 160
Parameter
Number
Group Name Setting Range Default Page
P.23 06-02
Stall prevention operation
level correction factor
0～200%
99999 108
99999: Stall prevention operation level is the setting
value of 06-01(P.22).
P.24 04-03 Speed 4
0～599.00Hz
99999 99
99999: Off
P.25 04-04 Speed 5 Same as 04-03 99999 99
P.26 04-05 Speed 6 Same as 04-03 99999 99
P.27 04-06 Speed 7 Same as 04-03 99999 99
P.28 01-15
Output frequency filter
time
0～31 0 70
P.29 01-05
Acceleration/deceleration
curve selection
0: Linear acceleration /deceleration curve
0 63
1: S shape acceleration /deceleration curve 1
2: S shape acceleration /deceleration curve 2
3: S shape acceleration /deceleration curve 3
P.31 00-12
Soft-PWM carrier function
selection
0: Off
0 54
1: When 00-11(P.72)<5,Soft-PWM is on(only apply to
V/F control)
2：When 00-11(P.72)＞9, if the IGBT temperature is
high, carrier frequency will decrease automatically,
when temperature go back to normal, carrier
frequency go back to 00-11(P.72) value
P.32 07-02
Serial communication
baud rate
0：baud rate :4800bps
1 114
1：baud rate :9600bps
2：baud rate :19200bps
3：baud rate :38400bps
P.33 07-00
Communication protocol
selection 0：Modbus protocol
1 114
1：Shihlin protocol
P.34 07-11
Communication
EEPROM write-in
selection
0：When writing parameters in communication mode,
write in RAM and EEPROM
0 129
1：When writing parameters through communication,
only write into RAM
P.35 00-19
Communication mode
selection
0: In communication mode, run signal and frequency
is given by communication.
0 56
1: In communication mode, run signal and frequency
is given by external signal.
P.36 07-01
Inverter communication
station number
0～254 0 114
P.37 00-08 Speed display
0：Display output frequency(not mechanical speed)
0.0 51 0.1~5000.0
1~50000
P.39 02-21
Maximum operation
frequency（Terminal 3-5
input / built-in keypad
knob） 50 Hz system:1.00～599.00Hz 50.00Hz
79
60 Hz system:1.00～599.00Hz 60.00Hz