Shihlin electric SL3 Series, User Manual

Page: 48 / 211

System parameter group 00
PARAMETER DESCRIPTION 46
5.1.2 Parameter restoration

Set parameters back to default.
Parameter Name Default Setting Range Content
00-02
Parameter
restoration
0
0 Off
1 Clear alarm history (P.996=1)
2 Reset inverter (P.997=1)
3 Restore all parameters to default (P.998=1)
4 Restore some parameters to default 1 (P.999=1)
5 Restore some parameters to default 2 (P.999=2)
6 Restore some parameters to default 3 (P.999=3)
Parameter restoration

1: When 00-02(P.996~P.999) is set to 1, screen will flash ，the alarm record will be erased after writing,
and 00-02(P.996~P.999) is reset to 0.

2: When 00-02(P.996~P.999) is set to 1, screen will flash ， and inverter will be reset, then
00-02(P.996~P.999) is reset to 0. After resetting the inverter, the accumulated values in “electronic thermal relay”
and “IGBT module thermal relay” will be set to zero.

3: When 00-02(P.996~P.999) is set to 3, screen will flash ，all the parameters will be restored to the
default values except the parameters in table 1 below. After parameters are restored, 00-02(P.996~P.999) is reset
to 0.
Exception
The parameters in table 1 below will not be restored to the default values:
Group No. Name
00-00 P.90 Inverter model
00-01 P.188 Firmware version
00-24 P.189 50Hz/60Hz switch selection
00-25 P.990 Parameter display mode setting
01-08 P.21 Acceleration/deceleration time increments
06-27 P.292 Total inverter operation time (minutes)
06-28 P.293 Total inverter operation time (days)
06-29 P.296 Total inverter power on time (minutes)
06-30 P.297 Total inverter power on time (days)

4 : When 00-02(P.996~P.999) is set to 4, screen will flash ，all the parameters will be restored to the
default values except the parameters in table 1 and table 2 below after writing. After parameters are restored,
00-02(P.996~P.999) is reset to 0.
Exception
The parameters in table 2 below and table 1 will not be restored to default values:
Setting