Shihlin electric SL3 Series, User Manual

Page: 185 / 211

Appendix 1 Parameter table
Appendix 181
Group
Parameter
Number
Name Setting Range Default Page
03-00 P.83
Terminal STF input
function
24：STF+RT+RM
0 89
25：STR+RT+RM
26：STF+RT+RL+RM
27：STR+RT+RL+RM
28: RUN(Inverter runs forward)
29: STF/STR(use with RUN signal, when ON, motor
runs reverse； when OFF, motor runs forward)
30: RES(External reset function)
31: STOP(Use as three line control with RUN signal and
STF-STR signal)
32: REX(Extend multi-speed to 16 levels)
33: PO(In “external mode", run programmed operation)
34: RES_E (External reset, valid only when alarm.)
35: MPO (In “external mode” run manual cycle
operation.)
36: TRI(Triangle wave function)
37~38：Reserved
39: STF/STR +STOP (Use with RUN signal, when ON,
motor runs reverse, when OFF, motor stops then runs
forward.)
40: P_MRS (Stops inverter output immediately by pulse
signal input)
41: PWM set frequency (Only valid with terminal STF
and parameter 03-00(P.83))
42：Reserved
43: RUN_EN (Enable digital input terminal operation)
44: PID_OFF (Enable digital input terminal turning off
PID)
45: Second frequency command source mode
03-01 P.84 Terminal STR input function Same as 03-00 1 89
03-03 P.80 Terminal M0 input function Same as 03-00 2 89
03-04 P.81 Terminal M1 input function Same as 03-00 3 89
03-11 P.85
Terminal A-C output
function
0: RUN(Output when inverter running)
5 92
1: SU(Output when reach target frequency)
2: FU(Output when reach 03-21 03-22 value )
3: OL(Output when overload)
4: OMD(Output when output current is zero)
5: ALARM(Output when alarm)
6: PO1(Output when in program operation step)
7: PO2(Output when in program operation cycle)
8: PO3(Output when in program operation pause)
9~10：Reserved
11：OMD1(Output when output current is zero 1)
12 ：OL2(Output when over torque)