Shihlin electric SL3 Series, User Manual

Page: 40 / 211

Basic operation steps for different modes
BASIC OPERATION 38
4.3.3 Basic operation steps for JOG mode (00-16(P.79)＝0 or 1)
Step Description
1
•Switch operation mode to JOG mode and indicator in will light up, the display shows .
Note: 1. For detailed operating procedures for the monitor mode, please refer to section 4.2.
2
• Press to run the motor. At this point, indicator in will flicker, indicating that the motor is running.
• Release to decelerate the motor until it comes to a full stop. Indicator in will not turn off until the inverter
stops the output.
Note: 1. For detailed operating procedures for monitor mode, please refer to section 4.2.3.
2. In JOG mode, target frequency is the value of 01-13(P.15), and the acceleration / deceleration time is the value of
01-14(P.16). Please refer to section 5.2.7 JOG operation.
4.3.4 Basic operation steps for communication mode (00-16(P.79)＝3)

In communication mode, user can set parameters and run/stop or reset inverters by communication. Please refer
to Communication function related parameters
for details.
4.3.5 Basic operation steps for combined mode 1 (00-16(P.79)＝4)
Step Description
1
• In Combined Mode 1, indicator
will light up.
Note: 1. For detailed operation procedures for monitor mode, please refer to section
4.2.
2
• Enter frequency setting mode and write target frequency into memory.
Note: For setting details, please refer to section 4.2.4
.
3
• Set target frequency by built-in keypad and start the inverter by terminal
STF/STR
.
• At this point, indicator in will flicker, indicating that the motor is running.
Note: For detailed operation procedures for monitor mode, please refer to section
4.2.3.
4
• When terminal STF/STR signals turn off, motor will decelerate until it comes to a full stop.
• Indicator in
will not turn off until the inverter stops outputting.
4.3.6 Basic operation steps for combined mode 2 (00-16(P.79)＝5)
Step Description
1
• In Combined Mode 2, indicating lamp will light up.
Note: For selecting and switching the operation mode, please refer to Section
4.2
.
2
• Target frequency is set by external terminals (default priority from high to low):
• If the programmable operating mode is chosen, please refer to section 5.4.1 function selection of digital input and 5.5.2
programmed operation mode.
• If target frequency is set by multi-speed stage levels, please refer to section 5.5.1 16 step speed.
• If target frequency is set by input signal across terminal 3-5, please refer to section 5.3.3 terminal 3-5 signal selection
and processing .
3
•
Press to run the motor. At this point, indicator will flicker to indicate that the motor is running.
Note: 1. For detailed operation steps for monitoring mode, please refer to section 4.2.3.
2. While the motor is running, the user can enter frequency setting mode to change target frequency for regulating
the motor speed.
4
• Press and the motor will begin to decelerate until it comes to a full stop.
• Indicator in will not turn off until the inverter stops outputting voltage.