SEW-Eurodrive MOVIDRIVE MD*60A Series, Operating Instructions Manual

Page: 58 / 102

56
MOVIDRIVE
®
MD_60A Operating Instructions
Starting the motor
Manual operation The inverter can be controlled using the DBG11A keypad using the manual operation
function. The 7-segment display on the unit shows "H" during manual mode.
In order for manual operation to be started, there must be a "0" signal sent to binary
inputs X13:2 (DIØ1) "CW/stop", X13:3 (DIØ2 "CCW/stop") and X13:4 (DIØ3 "Enable/
rapid stop"), if programmed. The binary inputs are then without any functions for the
duration of manual operation, with the exception of X13:1 (DIØØ "/Controller inhibit").
Binary input X13:1 (DIØØ "/Controller inhibit") must get a "1" signal to enable the drive
to be started in manual operation. The drive can also be stopped in manual operation
by X13:1 = "0".
The direction of rotation is not determined by the "CW/stop" or "CCW/stop" binary
inputs. Instead, you select the direction of rotation using the keypad (
→
Fig. 150).
Manual operation remains active even after the supply system power has been switched
off/on. The inverter is then inhibited, however. A change of direction command using the
→
or
←
key produces an enable and a start in the selected sense of rotation at n
min
. The
speed is increased and decreased using the
↑
and
↓
keys. The modification speed is
150 rpm per second.
02406AEN
Fig. 49: Manual mode with DBG11A
↓
-key: decrease speed
↑
-key: increase speed
Q-key Q-key
E-key
↑ ↓
- or -key
→
-key
880 _OFF
MANUAL OPERATION
88 OFF
MANUAL OPERATION
0
_ DIR. OF ROTATION
L
<E>=EXIT R
_ 0%In 0 rpm
<Q>=STOP R
_ 0%In 0 rpm
L <Q>=STOP
←
-key
←
-key
←
-key
→
-key
→
-key
The signals at the binary inputs take effect as soon as manual operation is finished.
Binary input X13:1 (DIØØ) /Controller inhibit does not have to be switched from "1" to
"0" and back to "1". The drive can start according to the signals at the binary inputs and
the setpoint sources.
0 0
I