4-39
4 Adjustment
4
8
Set the SV-GG media on the machine and lower the Pinch
Rollers.
Turn on the sub power switch while pressing [ ], [ ] and [ ]
keys to enter the SERVICE MODE.
9
Select [AUTO] under the [PRINT&CUT ADJ.] menu.
PRINT / CUT OFFSET ADJUSTMENT will be done
automatically after printing Crop Marks when the
[ENTER] key is pressed.
10
Select [TEST PRINT] under the [PRINT&CUT ADJ.]
menu.
When the [ENTER] key is pressed, Crop Marks will be
printed on both edges of the media and will be cut.
Make sure there is no shifting between the positions of
the Crop Mark and Cutting.
In case of correcting the error, perform Manual
Adjustment.
[AUTOMATIC ADJUSTMENT]
[CHECKING]
[ ], [ ], [ ] + POWER ON
[ MENU ] key
SERVICE MENU
Menu
[ENTER]
SERVICE MENU
PRINT&CUT ADJ.
PRINT&CUT ADJ.
AUTO
PRINT&CUT ADJ.
COMPLETED
SERVICE MENU
PRINT&CUT ADJ.
PRINT&CUT ADJ.
TEST PRINT
[ENTER]
TOOL / CROP MARK SENSOR POSITION
ADJUSTMENT needs to have been done before
carrying out this adjustment.
11
When Cutting is shifted from the Crop Mark only at the left
side, it should be caused by the expansion or contraction of
the Linear Encoder Scale. Perform [LINEAR CALIB.] in the
Service Menu.
SERVICE MENU
LINEAR CALIB.
NOW PROCESSING..
LINEAR CALIB.
SETUP COMPLETED
Summary of Contents for SP-300
