3 Replacement of Main Parts
3-30
3
11
12
Pull out the INK TUBEs from the CABLE BEAR.
Put the new INK TUBEs in the CABLE BEAR through
the THUBE HOLDER and connect the INK TUBEs to
the CARTRIDGE HOLDERs and INK DAMPERs.
Be careful which hole of the TUBE GUIDE
should be used for each INK TUBE.
9
Disconnect 2 FLEXIBLE CABLEs that are coming from
the CABLE BEAR from the CARRIAGE BOARD.
10
Remove the GUIDE PLATEs of the CABLE BEAR.
Then, take out the FLEXIBLE CABLEs from the CABLE
BEAR.
GUIDE PLATE
Summary of Contents for SP-300
