3 Replacement of Main Parts
3-7
3
Enter the SERVICE MODE and perform the following
adjustments.
HOW TO CLEAR THE HEAD INFORMATION
After THERMISTER CHECK and HEAD ALIGNMENT,
clear the HEAD INFORMATION from the SERVICE
MENU > HISTORY MENU > HEAD GROUP. When you
replaced the left Head, clear SHOT COUNT 1 and 2.
When you replaced the right Head, clear the SHOT
COUNT 3 and 4.
22
1. THERMISTER CHECK
2. HEAD ALIGNMENT
3. HEAD INFORMATION CLEAR
4. TOOL / CROP MARK SENSOR POSITION
SERVICE MENU
HISTORY MENU
SHOT COUNT 1
21166 KShots
SHOT COUNT 2
21166 KShots
SHOT COUNT 3
21166 KShots
[ ]
HISTORY MENU
MOTOR GROUP
SHOT COUNT 1
CLEAR
SHOT COUNT 2
CLEAR
SHOT COUNT 3
CLEAR
[ ]
HISTORY MENU
HEAD GROUP
SHOT COUNT 4
21166 KShots
SHOT COUNT 4
CLEAR
21
From the menu (NOT from the service menu), select
[INK CONTROL] > [HEAD REPLACE], and press the
ENTER key.
INK CONTROL
EMPTY MODE
INK CONTROL
PUMP UP
INK CONTROL
HEAD WASH
INK CONTROL
HEAD REPLACE
MENU
INK CONTROL
EMPTY MODE
STOP STOP
Summary of Contents for SP-300
