4-38
4 Adjustment
4
4
Select [SCAN SETTING] from the [PRINT&CUT ADJ.]
menu and enter the correction-value found in the Test
Pattern.
Select [FEED SETTING] from the [PRINT&CUT ADJ.]
menu and enter the correction-value found in the Test
Pattern.
5
6
Select [TEST PRINT] under the [PRINT&CUT ADJ.]
menu.
Test Pattern will be printed and cut when the [ENTER]
key is pressed.
[ENTER]
SCAN SETTING
-0.40mm -0.40mm
SERVICE MENU
PRINT&CUT ADJ.
PRINT&CUT ADJ.
SCAN SETTING
[ENTER]
SERVICE MENU
PRINT&CUT ADJ.
PRINT&CUT ADJ.
FEED SETTING
FEED SETTING
-0.15mm -0.23mm
SERVICE MENU
PRINT&CUT ADJ.
PRINT&CUT ADJ.
TEST PRINT
[ENTER]
7
If the cutting line is shifted from the printed image, fine
adjust the error in Scan Direction and Feed Direction in
the step 4 and 5 .
Summary of Contents for SP-300
