4-32
4 Adjustment
4
4-7 CROP MARK SENSOR ADJUSTMENT (Referential Time : 10min.)
1
Remove the FRONT COVER and FRONT RAIL
COVER.
[About CROP MARK SENSOR ADJUSTMENT]
This adjustment is for adjusting the sensitivity of the CROP MARK SENSOR.
If not adjusted, crop marks can not be read correctly and result in a problem that
the cutting shifts from the printing.
2
3
[ ], [ ], [ ] + POWER ON
[ MENU ] key
SERVICE MENU
Menu
Turn on the sub power switch while pressing [ ], [ ]
and [ ] keys to enter the SERVICE MODE.
Set the SV-GG media on the machine, and lower the
Pinch Rollers.
FRONT COVER
FRONT RAIL COVER
Remove the TOOL CARRIAGE COVER and
CARRIAGE BOARD COVER.
TOOL CARRIAGE COVER
CARRIAGE BOARD COVER
Summary of Contents for SP-300
