ROJ PCS 200, Original Instructions Manual, Page: 82 / 112

User Manual
PCS 200 Kit - 3.41 -
xx = it indicates the motor which generated the error
1-32 Seeding disc 1-32
33-40 Fertilizer spreader 1-8
49-56 Micro-granulator A 1-8
57-64 Micro-granulator B 1-8
Error
code
Message Solution
battery voltage
1xx12 Find rotor position error Not active on customer release
1xx13 Safety switch open
Close lid or seeding element cover. Check
security switch
1xx14 Pwm control volt
Cycle power of the system from battery
disconnect. Contact supplier if not solved
1xx15 Position control error
Cycle power of the system from battery
disconnect. Contact supplier if not solved
1xx16 Blocked Seeding disk
Check seeding disk for stuck seeds or
distributor of stuck/blocking product.
1xx17 Low voltage
Check PTO speed to be according to
specifications. Check alternator voltage.
Check battery connection and fuses
1xx26 Seed selector
Verify that there isn't any material (seeds,
dust, etc.) preventing the correct movement
of seed selector. Verify that seed selector
cam is fitted properly on seed selector motor
shaft. From the menu\Diagnostic\Test\Seed
Selector, press "Homing" button to perform
the homing procedure
1xx30 Generic Recoverable emergency
1xx80 High number of doublets
Check at every single turn, adjust the seed
selector position to a lower set value.
1xx81 High number of missings
Check at every single turn, adjust the seed
selector position to a higher set value.
1xx83 High number of missings
Quick check less than one turn, check the
pressure rate and the seeds selector position
1xx84 Prefill not completed
Verify that vacuum is correct and seeds are
present in the hopper
1xx85 High number of doublets
Long period alarm, adjust the seed selector
position to a lower set value.
1xx86 High number of missings
Long period alarm, adjust the seeds selector
position to a higher set value, for example to
detect a plugged disk hole.
1-1xx14 Pwm control volt
Cycle power of the system from battery
disconnect.
Contact supplier if not solved.
1-1xx15 Position control error
Cycle power of the system from battery
disconnect.
Contact supplier if not solved.