ROJ PCS 200, Original Instructions Manual

Page: 19 / 112

General Information
PCS 200 Kit - 1.9 -
1.4.3 Warning for residual risks
Despite all the security measures taken and listed in the previous paragraph, there
could be some residual risks during the installation, the use and the maintenance
operations due to:

the presence of electricity even when the agricultural machine is stopped

the presence of potential high temperatures in the geared motors groups
In these phases it is therefore necessary to use the utmost care when working in
order to avoid any dangerous situations.
The presence of these residual risks is indicated by special warning labels attached
to the enclosures of the geared motor built-in drives.
It indicates the need to pay due attention in order to avoid the risk of burns.
1.4.4 Warnings and Behaviour rules for the Operator
To avoid any risk condition for the operator and any damages to the equipment, it is
recommended to strictly follow the warnings and behaviour rules herein listed.
☞
ROJ will assume no liability for any damages to people and/or properties arising from
the non-observance of these warnings.

Operators shall be properly trained to make best use of the equipment so to avoid
risks, and must have read and understood the instructions and warnings given in
this manual.

All personnel in charge for the installation and maintenance of the machine must
read this manual before performing any electrical or mechanical operations.

All personnel operating on the system must wear appropriate clothing, avoiding or
paying due attention in case of:
−
loose clothing
−
necklaces, bracelets and rings
−
wide sleeves
−
long hair
−
dangling ties or scarves

Before using the machine equipped with the PCS 200 System, make sure that
any dangerous safety conditions have been properly eliminated, that all guards or
other protections are properly installed and that all safety devices are efficient
.

Do not start the machine in case of faults.
DO NOT attempt to remove or by-pass any the safety measures: doing so will
reduce the safety level of the system.
DO NOT perform any type of work with machine powered up.