ROJ PCS 200, Original Instructions Manual

Page: 80 / 112

User Manual
PCS 200 Kit - 3.39 -
Error
code
Message Solution
1060 Error overflow 1 Contact technical support
1061 Error overflow 2 Contact technical support
1062 Internal error Contact technical support
1063 Log checksum failure Contact technical support
1470 Connection timeout Check CAN cable connection between ECU and HMI
1471 Invalid protocol version debug Not active on customer release
1472 Invalid protocol version
SW version of ECU and HMI are not compatible.
Make sure that latest SW updates have been
correctly downloaded to ECU and HMI. Note
1480 Missing connection ECU / MD
Check CAN cable connection between ECU and
DMD. Check supply cable to ECU. Check battery
voltage
1481 Connection timeout ECU / MD
Check connection between ECU and DMD or
between DMD
1490 Initialize timeout (%1) Contact technical support
1550 Connection timeout
Check connection between ECU and remote
terminal
1600 Machine taxing position
Machine in transport position (lifted) If this is
happening when machine is supposed to be
seeding, check cabling and machine position sensor
1610 Pressure sensor failure Check connection of pressure sensor
1611 Pressure out of range
Adjust PTO speed so that vacuum pressure is within
the range
1612 Pressure range min > max
Check min and max limit setting of pressure so that
min < max
1701 MD protocol error
Update DMD with latest SW and check that
addressing procedure has been correctly completed
1703 Configuration and setup parameters lost
Machine configuration parameters have been reset
to default. Check and correct configuration
parameters where applicable
1801 Invalid configuration or MD address
Check MD fuses. Addressing procedure of DMD has
to be performed
2000 Data checksum Contact technical support
2001 Invalid checksum Contact technical support
2003 Debug mode Not active on customer release
2007 Event log failure Contact technical support
2008 FRAM checksum error Contact technical support
2009 FSM queue overflow Contact technical support
2100 Cpu watch dog Contact technical support
2101 Software trap Contact technical support
2200 Speed sensor failure Check speed sensor cabling
2500 Group A parameters mismatch
Not possible to set that combination of parameters
(number of disk holes, seeding distance)
2501 Group B parameters mismatch
Not possible to set that combination of parameters
(number of disk holes, seeding distance)