Chapter 2 Front Panel Operations
RIGOL
DL3000 User’s Guide
2-41
(2)
Press EndState to switch the last working state. You can also use the
Left/Right arrow key or the knob to switch it.
Set TRIG_SRC
Three triggers are available in List mode: BUS trigger, TRAN trigger, and DIGIO
trigger.
(1)
In the main interface, press TRIG_SRC to switch the parameter focus to
"TRIG_SRC".
(2)
Press TRIG_SRC to select the type of the trigger source. You can also use
the Left/Right arrow key or the knob to select it.
Set Parameter List
The parameter list consists of the following parameters: Step, Value, Duration,
Slew (only available in CC mode), V_Sampling (V)/C_Sampling (A). Step
indicates the number of steps; Value indicates the value set for each step;
Duration indicates the dwell time for each step; Slew indicates the slew rate for
each step; V_Sampling (V) indicates the readback sampling voltage; and
C_Sampling (A) indicates the readback sampling current. If the scrollbar is
shown at the right side of the parameter list, it indicates that not all parameters
are displayed in the current interface. At this time, press the Up/Down arrow key
to go to the next page.
(1)
Select Step
The Step value in the parameter list is related to the setting of "Steps" in the
menu. For example, press Steps to set it to 4, then the first 4 steps in the
parameter list and the relevant parameters are highlighted.
If the number of steps that you set is a small value, you only need to use
the Left/Right arrow key or the knob to directly select the desired number of
steps.
If the number of steps that you set is a large value, you can input the
desired steps by using the numeric keys first. After that, you will directly go
to the column under the desired steps. For example, if you set Steps to 300,
and you want to set the parameters for Step 250, then use the numeric
keys to input 250 and you will go to Step 250 directly. At this time, you can
set the relevant parameters.
If the parameter focus is currently not on the "Step" line, first press the
Up/Down arrow key to switch the parameter focus to the "Step" line, and
then select the desired steps.
Tip
When the number of execution times (Circle) is set to "Infinite", "EndState" is
disabled and grayed out.
Summary of Contents for DL3000 Series
