Raritan DOMINION SX -, User Manual

Page: 52 / 226

34 D
OMINION
SX U
SER
G
UIDE
6.
Select the escape mode. The default is
None
. Change as follows:
•
Select
Control
from the drop-down menu in the
Escape Mode
field.
•
Type the
Escape Character.
The default for the Dominion SX is
]
(closed bracket ).
7.
Select the terminal emulation type from the drop-down menu in the Emulation field. The
choices are:
•
VT100
•
VT220
•
VT320
•
ANSI
8.
If you plan to use Direct Port Access (DPA), you must enter the DPA IP Address, as well as
one or both of the following:
•
The port number, such as 7700, in the DPA
SSH TCP Port
field
•
The port number, such as 8800, in the DPA
Telnet TCP Port
field .
9.
Click
OK
.
Direct Port Access
To configure direct port access:
1.
Click the
Setup
tab, and then click
Services
. The Network Service Settings screen appears.
The
Direct Port Access Mode
field is at the bottom of the screen.
Figure 28 Direct Port Access Mode Field
2.
Go to the
Direct Port Access Mode
field. The default is
Normal
, which means disabled. To
enable DPA, select either
IP
or
TCP Port
from the drop-down menu.
3.
Click
OK
to save this information. The screen displays the following message:
The system will need to be rebooted for changes to take effect.
4.
Reboot now or reboot after completely configuring for DPA.
5.
Click the
Setup
tab, and then click
Port Configuration
. The Port Configuration screen
appears. (Figure 26).
6.
Select the ports to configure for direct port access:
•
To select specific ports, click the checkboxes to the left of the port number. You can
select more than one. When you have finished, lick
Edit
.
•
To select all the ports, click
Select All
.
The Edit Port Configuration screen appears (Figure 27). The DPA fields are at the bottom of
the screen.
7.
Type the DPA IP address of the DSX, and the DPA ports used for SSH and Telnet in the
appropriate fields.
8.
Click
OK
to save this information.
9.
Reboot the DSX unit. This is necessary for the direct port access settings to take effect.
.