R&S ESR Series, User Manual

Page: 160 / 1126

Receiver Mode
R&S
®
ESR
157 User Manual 1175.7068.02 ─ 12
The submenu contains more result displays.
Note that the Spectrogram is available for the Scan display and the IF Analysis. To add
the Spectrogram, either Scan or IF Analysis have to be turned on already. If you are
using the Scan and IF Analysis simultaneously, the Spectrogram is unavailable.
The Spectrogram of the Scan is independent of the Spectrogram available for IF
Analysis and vice versa. Therefore you should regard the two Spectrograms as sepa-
rate result displays. For more information see
Chapter 5.1.6, "Spectrogram" ,
on page 151.
Remote command:
CALCulate<n>:FEED
on page 637
Ba Scan
Shows the Bargraph and Scan result displays.
Ba IF Analysis
Shows the Bargraph and IF Analysis result displays.
Bargraph
Turns the Bargraph result display on and off.
IF Analysis
Turns the IF Analysis result display on and off.
Scan
Turns the Scan result display on and off.
Spectrogram
Turns the Spectrogram result display on and off.
5.1.7.3 Bargraph Control
The "Measurement Configuration" menu contains functionality to configure the bar-
graph.
SCPI commands:
Querying the signal level:
"Querying bargraph results" on page 644
Querying the upper and lower value of the bargraph scale:
DISPlay:BARGraph:LEVel:LOWer?
on page 638
DISPlay:BARGraph:LEVel:UPPer?
on page 638
Continuous Bargraph / Single Bargraph ..................................................................... 158
Bargraph Maxhold .......................................................................................................158
Maxhold Reset ............................................................................................................ 158
Measurements and Result Displays