Remote Control
R&S
®
ESR
732
User Manual 1175.7068.02 ─ 12
[SENSe:]POWer:ACHannel:NAME:ALTernate<channel>
<Name>
This command defines a name for the specified alternate channel. The name is dis-
played in the result diagram and the result table.
Suffix:
<channel>
.
1...11
the alternate channel
Parameters:
<Name>
*RST:
ALT<1...11>
Example:
POW:ACH:NAME:ALT3 'XYZ'
Defines the name of the third alternate channel as 'XYZ'.
Manual operation:
See
[SENSe:]POWer:ACHannel:NAME:CHANnel<channel>
<Name>
This command defines a name for the specified TX channel. The name is displayed in
the result diagram and the result table.
Suffix:
<channel>
.
1...12
the TX channel
Parameters:
<Name>
*RST:
TX<1...12>
Example:
POW:ACH:NAME:CHAN3 'XYZ'
Defines the name of the third transmission channel as 'XYZ'.
Manual operation:
See
[SENSe:]POWer:ACHannel:SPACing[:ACHannel]
<Spacing>
This command defines the spacing between the carrier signal and the adjacent chan-
nel (ADJ). The modification of the adjacent-channel spacing (ADJ) causes a change in
all higher adjacent-channel spacings (ALT1, ALT2, ...): they are all multiplied by the
same factor (new spacing value/old spacing value).
Parameters:
<Spacing>
100 Hz to 20 GHz
*RST:
14 kHz
Example:
POW:ACH:SPAC 33kHz
Sets the spacing between the carrier signal and the adjacent
channel to 33 kHz, the alternate adjacent channel 1 to 66 kHz,
the alternate adjacent channel 2 to 99 kHz, and so on.
Manual operation:
See
Remote Commands in Spectrum Analyzer Mode
