Remote Control
R&S
®
ESR
994
User Manual 1175.7068.02 ─ 12
ENHanced
If subsequent commands are not found on the same tree level
as the previous command, the SCPI parser searches "back-
wards up the tree" of defined SCPI commands. If the command
is found at a higher node, that command is used. Only if the
command is not found anywhere, an error message is returned.
*RST:
setting is retained
Example:
*RST
:SYSTem:TWALKing ENHanced
:SENSe:SWEep:MODE LIST
INIT:CONT OFF
LIST:RANG4:DEL;RANG3:DEL
//without enhanced tree walking this command would deliver an
error
Manual operation:
See
11.16
Status Register
For more information on the contents of the status registers see the following sections.
Status registers in receiver mode:
●
●
"STATus:QUEStionable Register"
●
"STATus:QUEStionable:FREQuency Register"
●
"STATus:QUEStionable:LIMit Register"
●
"STATus:QUEStionable:LMARgin Register"
●
"STATus:QUEStionable:POWer Register"
●
"STATus:QUEStionable:TRANsducer Register"
Status registers in spectrum mode:
●
●
"STATus:QUEStionable Register"
●
"STATus:QUEStionable:ACPLimit Register"
●
"STATus:QUEStionable:FREQuency Register"
●
"STATus:QUEStionable:LIMit Register"
●
"STATus:QUEStionable:LMARgin Register"
●
"STATus:QUEStionable:POWer Register"
11.16.1
General Status Register Commands
...............................................................................................995
Status Register
