Remote Control
R&S
®
ESR
714
User Manual 1175.7068.02 ─ 12
<k>
1...8
Selects the limit line.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:LIM4:LOW:STAT ON
Switches on limit line 4 (lower limit).
CALCulate<n>:LIMit<k>:LOWer:THReshold
<Threshold>
This command defines a threshold for relative limit lines.
The R&S
ESR uses the threshold for the limit check, if the limit line violates the thresh-
old.
Suffix:
<n>
.
irrelevant
<k>
1...8
Selects the limit line.
Parameters:
<Threshold>
Numeric value that defines the threshold.
The unit depends on
*RST:
-200 dBm
Example:
CALC:LIM2:LOW:THR -35DBM
Defines an absolute threshold value for limit line 2.
CALCulate<n>:LIMit<k>:UPPer[:DATA]
<LimitLinePoints>
This command defines the vertical definition points of an upper limit line.
If the measured values exceed the UPPer limit line, the limit is violated.
Suffix:
<n>
.
irrelevant
<k>
1...8
Selects the limit line.
Parameters:
<LimitLinePoints>
Variable number of x-axis values.
Note that the number of horizontal values has to be the same as
the number of vertical values set with
ESR either adds
missing values or ignores surplus values.
The unit depends on
*RST:
(LIMit:STATe is set to OFF)
Remote Commands in Receiver Mode
