Remote Control
R&S
®
ESR
638
User Manual 1175.7068.02 ─ 12
.................................................................................. 638
DISPlay:BARGraph:TCOupling[:STATe]
............................................................................638
[SENSe:]DETector:RECeiver[:FUNCtion]
..........................................................................639
DISPlay:BARGraph:LEVel:LOWer?
This command queries the minimum level of the bargraph.
Example:
:DISP:BARG:LEV:LOW?
Usage:
Query only
DISPlay:BARGraph:LEVel:UPPer?
This command queries the maximum level of the bargraph.
Example:
:DISP:BARG:LEV:UPP?
Usage:
Query only
DISPlay:BARGraph:PHOLd[:STATe]
<State>
This command switches the indication of the maxhold value of the bar graph measure-
ment on or off.
Parameters:
<State>
ON
OFF
*RST:
OFF
Example:
DISP:BARG:PHOL ON
Manual operation:
See
DISPlay:BARGraph:PHOLd:RESet
This command resets the maxhold value of the numeric indication of the bargraph
measurement.
Example:
:DISP:BARG:PHOL:RES
Usage:
Event
Manual operation:
See
DISPlay:BARGraph:TCOupling[:STATe]
<State>
This command couples or decouples the bargraph detector and scan trace detector.
Parameters:
<State>
ON | OFF
*RST:
OFF
Remote Commands in Receiver Mode
