10.36
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
1.
Place the vehicle on a level surface with the
headlight approximately 25' (7.6 m) from a wall.
2.
Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the
same height.
3.
Start the engine and turn the headlight switch to high
beam.
4.
Observe headlight aim. The most intense part of the
headlight beam should be aimed 2” (5.1 cm) below
the mark placed on the wall in Step 2.
NOTE: Rider weight must be included on the
seat. On machines with separate low beam
lights, the drop should be 8, (20.3 cm) in 25' from
the center of the low beam lamp.
5.
Adjust beam to desired position.
Lower Headlamp Removal / Installation
1.
Turn the back of the headlamp harness in a counter-
clockwise direction to loosen.
2.
Pull the harness assembly out from the headlight
assembly.
3.
Remove the lamp and replace with a new headlamp.
NOTE: Do not touch the new lamp with bare
fingers. Hold the plastic part (1) of the lamp. Oil
from your skin leaves a residue, causing a hot
spot that will shorten the life of the lamp.
ELECTRICAL
