Planex CQW-AP108AG, Installation And Configuration Manual, Page: 182 / 301

Using the Network Topology Menu
Installation and Configuration Guide, (CQW-AP108AG) 169
Perform the following functions from this panel:
Figure 121: Network Topology - AP Enrollment - Enroll an AP Entry Panel
The Enroll an AP panel contains information that uniquely identifies the AP. To verify the identity
of the AP, compare the following information to the information on the paperwork shipped with the
AP:
When an AP is enrolled, it is configured with the enrolling AP’s bootstrap configuration. Refer to
Chapter 3, “Installing the Access Point,” for bootstrap configuration details.
Function Description
Enroll an AP 1 Select the desired AP, and click Enroll to open the Enroll an AP Entry
panel (Figure 121). If the AP is not in the factory default state, a message is
presented. Click the AP link to open the web interface for the AP and reset
it to the factory default configuration.
2
After verifying the information on the panel (Table 13), enter the correct
password, and click
Enroll
. It takes a couple of minutes to enroll the AP.
Delete an AP Select an AP and click
Delete
to remove it from the list.
Refresh Click to update the display.
Rediscover Now Scan the network to discover APs and update the Not Enrolled APs table.
Table 13: AP Enrollment Information
Field Description
AP Name Verify the alphanumeric name of the AP. The default is the IP address.
IP Address Verify IP address of the AP.
Serial Number Verify the AP serial number.
Thumbprint Verify the thumbprint, which uniquely identifies the AP for security purposes.
Password Enter and confirm the PLANEX-supplied password.
Security Portal Indicate whether to use the AP as a standby security portal. With a backup
security portal, a copy of the user authentication database remains accessible
even if the NM Portal AP becomes unavailable.